Sierra de mesa

Start with a zero-clearance insert (to reduce chipout), a quality push stick or push block (for safety on narrow rips), and a reliable crosscut sled (for accurate, repeatable crosscuts). These three upgrades address the most common beginner table saw problems — tearout, kickback risk, and inaccurate crosscuts. Visit the Infinity Tools learning center for beginner table saw setup guides.

A stacked dado set uses two outer blades plus a set of chippers stacked on the arbor to cut a flat-bottomed groove wider than a standard saw kerf. The width is adjusted by changing which chipper combinations you stack. The Dadonator XL 8" dado set is designed for a 5/8" arbor — check your table saw's specifications to confirm arbor size compatibility before purchasing.

A zero-clearance insert replaces the stock throat plate with a blank that is then cut in place — with the blade raised through the blank — to create a kerf that exactly matches the blade width. The Betterly TruCut system provides pre-machined blanks and the hardware to create precise ZCI plates that support wood fibers right at the cut, dramatically reducing chipout.

A crosscut sled rides in both miter slots simultaneously, providing far more stability and a much larger fence reference surface than a miter gauge. It is especially useful for wide panels that would overhang a miter gauge fence. The TCS-200 professional crosscut sled is a precision option with a square fence and miter bar runners calibrated to standard miter slot dimensions.

The fence alone is not safe for very narrow rip cuts because the narrow offcut can contact the blade after separation. Use a thin rip guide that rides along the fence and provides a controlled gap between the fence and blade, keeping the narrow strip safely clear of the blade exit. For strips under about an inch, consider the bandsaw instead.

A blade splitter is a static plate mounted behind the blade that prevents the kerf from closing and pinching the blade, which causes kickback. A riving knife moves with the blade as it tilts and always stays close to the blade regardless of height setting. The laser-kerf blade splitter is a fixed splitter that provides kickback protection and is compatible with a zero-clearance insert when a riving knife cannot be used.

The precision miter bar is an accurately machined steel bar that slides in the miter slot of a table saw, router table, or bandsaw and serves as the foundation for building sleds and jigs. It measures 9-7/8" long by 3/4" wide by 3/8" thick, fitting the standard miter slot found on most woodworking machines sold in North America.

The JessEm Clear-Cut stock guides are spring-loaded hold-down guides that clamp to the rip fence and apply downward and lateral pressure to the workpiece throughout the cut. This keeps the board flat against the table and firmly against the fence, preventing drift and lifting that can cause an uneven cut or contact with the back of the blade.

Dado sets require a table saw with sufficient arbor length (typically 1" or more) to accommodate the stacked cutters, and the arbor bore must match (usually 5/8" in North America). Some contractor saws and smaller hybrid saws have arbors that are too short for a full dado stack. Consult your saw's manual for dado set compatibility before ordering the Dadonator dado set.

Yes — Infinity Tools will match eligible competitor prices. See the price match policy page for terms and how to submit a request. You can also contact us directly with any questions.